Shop
Pick your pack
Prototype run
You will see layer lines and small imperfections since these are being 3D printed. They do not affect how the SLIDESEAL works.
What one delivered prototype clip actually cost us:
- The clip itself
- $1.61
- Packaging
- $0.64
- Payment processing
- $0.29
- Printers, dryers and free samples
- $2.66
- Shipping
- Calculated at checkout
- What one clip costs us
- $5.20
- What you pay
- $5.00
- Prototype run Layer lines and all
- 30-day returns Full refund on return
- Printed in Oregon On our own machines
One piece
No spring, no hinge, no clasp. The part that fails isn’t on it.
Six inches of channel
Fold the bag, slide it on. It holds the whole fold instead of a couple of inches in the middle.
Magnets inside
Sealed in mid-print. Between bags it goes on the fridge, not in the drawer.
Care at a glance
- Hand wash Warm water, dish soap
- No dishwasher Heat warps it
- No microwave Or oven, or flame
- 130°F limit No hot cars
- Not for food Clips the bag, not the chips
Questions
Do packs come in one color or mixed?
One color per pack, never mixed. You pick the color, then the pack size. A 4-pack is four of the same clip.
How long until it ships?
Four printers, sixty-four clips a day, and one of us putting the magnets in by hand. Most orders go out with the next batch. If a lot land at once, yours waits for the one after and we’ll email you the date. We’d rather tell you that than promise two days and miss it.
What makes this a prototype?
It’s 3D printed on desktop machines in Albany, Oregon, instead of injection molded in a factory. Hold one at an angle and you’ll see the layer lines. Printed plastic is strongest across the layers and weakest between them, so if one is going to fail, that’s where. Whether the molded version gets made at all is what this run is meant to find out.
What if it breaks?
There’s no warranty on a prototype we’re selling at cost. If one breaks, tell us what you were doing when it did. That report is what this run is for.